Pacific Palisades Leaf 05 of 06

Pacific Palisades · undercounter

The Drawer Under the Stone: Palisades Undercounter Service

In a Palisades kitchen the Sub-Zero drawers or beverage unit usually sit beneath a slab of quartzite, marble or poured concrete that nobody wants to lift. Happily, the slab almost never has to budge. Below: how a small refrigerator escapes from beneath heavy stone, what a technician can do with it in place, and what you can get ready before the visit.

4.8/5 from 187 client reviews How the rating is counted

How an undercounter unit comes out from under the counter

A Sub-Zero drawer cabinet is meant to travel in and out of its cavity while the countertop stays put. The order below is the general sequence a technician follows. Every installation is a little different, so treat it as a description of the job, not instructions to try alone.

  1. Power off and drawers emptied

    The unit is unplugged or its circuit switched off, and the drawers or shelves are cleared. A loaded drawer adds weight at the front and makes the cabinet want to tip forward once it is free.

  2. Front grille and kick plate removed

    Drawer units take their air in and send it out at toe level, through that strip at the bottom. Taking off the grille exposes the leveling legs, the anti-tip hardware and, on many installs, the first look at the condenser.

  3. Brackets released

    Most built-in drawers are tied to the cabinetry or to the underside of the counter so they cannot rock out when a drawer is pulled hard. Those screws or brackets come loose before anything slides.

  4. Legs lowered to clear the slab

    The unit is let down on its adjustable legs until the top clears the stone edge by a safe margin. Thick stone with a deep overhang or a built-up apron is where this step needs the most care.

  5. Slid out over a protected floor

    The cabinet is eased forward on a pad or board so its feet do not scrape the floor, with an eye on the power cord and any water line behind it. It comes forward just far enough for the fault at hand; plenty of jobs happen with the cabinet halfway out.

  6. Back in, leveled and secured

    After the repair the unit goes back on the same path, is raised and leveled so the drawers close evenly, and the brackets go back in. Then it runs while the technician listens and checks that air moves through the front.

Why stone changes the job, and why it usually does not stop it

A heavy counter matters for two reasons. First, the opening was often cut to a tight fit, so there is very little room above the unit once it is leveled. Lowering the legs is how that room is found, and on some installs it is a fine margin. Second, stone has no give. A laminate or wood top will flex slightly if someone pushes up on it; a slab will not, and nobody enjoys finding a chip on a quartzite edge. That is why the unit comes down and out, rather than the counter coming up.

Plenty of work never needs the unit out at all. Drawer gaskets, drawer glides, the front grille and the fan behind it, many control and sensor checks: all of these can be handled from the kitchen side once the drawers are lifted off. Pulling the cabinet becomes necessary when the trouble is behind it or beneath it, such as a refrigerant-side fault, a connection at the back, or a drain or water line on a unit that has one.

The other thing a stone kitchen tends to bring is a custom panel on the drawer fronts, matched to the cabinetry. Panels add weight to each drawer and can be scratched if they are leaned against the counter edge. A technician will take them off or protect them, but it helps to know before the visit whether yours are panels or stainless, so the right supplies come along.

How do you pull out an undercounter refrigerator?

Switch off the power and empty the drawers, remove the front kick plate, release the brackets that hold the unit to the cabinets or counter, then lower the leveling legs until the top clears the counter and slide it forward on a protected floor. With heavy stone above and water or power lines behind, it is safer to have a technician do it.

Getting the kitchen ready for the visit

Ten minutes of preparation means the appointment goes on the refrigerator instead of on moving stools and baskets.

  • Empty the drawers or beverage shelves and keep the contents in a cooler or the main refrigerator
  • Leave open floor ahead of the drawers roughly as deep as the cabinet itself, with space to kneel beside it
  • Move rugs, runners and stools away from the opening
  • Locate the breaker or receptacle powering the drawers, assuming someone in the house knows
  • Note whether the drawer fronts are custom panels or stainless
  • For a unit plumbed for water, find its shutoff, usually below the sink or inside a neighboring cabinet
  • When booking, describe parking on your street and which door leads most directly to the kitchen

What moves the repair price on an installed unit

Coming out costs one $89 charge per trip, no matter how many Sub-Zero appliances get examined, and that charge is credited against the repair. You hear the repair figure once the unit has been inspected and before a screw is turned. Under a counter, the figure depends on:

  1. Front access versus full removal

    A repair done from the front with the drawers off is a different amount of work from one that needs the cabinet lowered, unhooked and slid out from under the stone.

  2. How tight the opening is

    A snug cut, a thick slab or an overhanging apron can mean extra care lowering and leveling the unit, both on the way out and on the way back in.

  3. Panels and trim

    Custom drawer panels or trim strips that have to be removed and refitted add steps to the job.

  4. Lines behind the unit

    A unit with a water connection or a drain needs those handled and checked for leaks after it goes back.

  5. What has failed

    A gasket or glide is one thing; a fan motor, a control or a sealed-system problem sits in another category for parts and labor alike.

Signs from a unit that lives under a counter

Undercounter units fail in their own ways because they are short, enclosed and fed air through one narrow front opening.

Drawers cool but never properly cold, front grille barely warm
Condenser coated with dust or kitchen grease, or the fan behind the grille has slowed
A rattle or buzz near the floor that comes and goes
Condenser fan blade catching or a bearing wearing out Read the note
One drawer closes softly, the other has to be pushed
The cabinet has sunk slightly out of level, or one glide is bent or worn
A strip of frost on just one side of a drawer
The gasket has lost contact along that edge and room air is leaking in Repair page
A damp patch on the floorboards at the toe kick
Trouble with a drain or supply line at the back, or sweating from a drawer that leaks air
Rust freckles on the grille or screws
Damp, salty air reaching exposed metal, more often in houses close to the bluffs Repair page

Palisades kitchens and the units under their counters

The neighborhood shapes the job in a few practical ways.

  • New and rebuilt kitchens

    After the Palisades fire, much of the neighborhood is rebuilding. A newly fitted drawer that runs warm in its first weeks is often an installation question, such as a blocked front vent, a unit off level or brackets fitted too tight, rather than a failing part.

  • The bluff edge over the highway

    Homes on the edge above Will Rogers State Beach and Castellammare take damp ocean air most mornings. Kitchens with large openings to a terrace see more of it on the front grille and hardware.

  • Temescal Canyon and the canyon streets

    Higher up and back from the ocean it is warmer and less humid, with more dust and dry leaves blowing about. Units here more often struggle with a coated condenser than with salt.

  • Sunset Boulevard and the drive in

    Most visits from the rest of our coast come along Pacific Coast Highway or across on Sunset. Both get slow at busy hours, which is why we confirm the time window when you book.

Why did my undercounter fridge stop cooling?

Most often its condenser or toe-level grille is matted with dust, the fan behind that grille has quit, a drawer seal has lost its grip, or a control or sealed-system part has failed. Move anything sitting against the low vent and make sure each drawer shuts all the way. Still warm by tomorrow? Book a diagnosis.

Two things owners often assume

  • ForThe stone counter has to be lifted to service a drawer underneath it.

    ReadSub-Zero designed these cabinets to drop on their legs and roll forward out of the cavity. The counter stays in place; the unit moves.

  • ForIf it is built in, it does not need any air around it.

    ReadIt needs air at the front. Every breath they take goes through that low grille, so a rug edge, a bin or a toe-kick heater against it can make a healthy unit run warm.

  • ForA drawer that refuses to shut means the drawer itself is broken.

    ReadOften the whole unit has settled slightly off level, or something has slipped behind the drawer. Leveling and clearing it is a smaller job than replacing glides.

Is there Sub-Zero undercounter repair in Pacific Palisades?

Yes. Malibu Sub-Zero Service works on Sub-Zero refrigerator and freezer drawers and beverage centers throughout the Palisades. You can call 24/7; appointments are daily from 8 AM till 6 PM. A $89 charge pays for the trip and inspection and is credited to the repair, whose price you get once the unit has been examined.

Questions about drawers and beverage units in the Palisades

Can you fix my Sub-Zero drawer without taking it out from under the counter?
Often, yes. Gaskets, glides, the front grille, the fan behind it and many control checks are done from the front. Removal is saved for faults located at the back or underneath.
Will pulling the unit out damage my stone countertop?
The unit is lowered on its legs before it moves, so it clears the slab rather than pushing against it. A snug cavity calls for more patience, and if your installation looks unusual in any way you will hear about it first.
My kitchen was just rebuilt and the new drawer runs warm. Is it broken?
Not necessarily. Fresh installations can end up with a covered toe vent, a cabinet slightly out of level or overtightened brackets. Those are checked first, before anyone talks about parts.
I have drawers and a full-size Sub-Zero. Do I pay the visit fee twice?
No. One trip, one $89 charge: the drawers and the big refrigerator can both be checked during the same appointment, and the charge is credited to any repair you approve.
Do you also look at outdoor drawers by the pool?
Outdoor-rated Sub-Zero undercounter units are on our list. Say it lives outdoors when you book, and see our Topanga page on undercounter units for how drier canyon air treats them by comparison.

Calls taken 24/7

Book a look at the unit under your counter

Phone or book online and tell us what the counter is made of and whether the drawer fronts are panels. More about these units is on the undercounter repair page and our Pacific Palisades overview.

$89 covers the trip, not each appliance; it is then knocked off the invoice when you green-light the repair.